Eyecatcher Clamping engineering

Centring clamp

Centring clamp

The centring clamp can be made in various sizes and variations. The centring clamp can be extended with various contour, claw and special clamps depending on individual requirements.

Clamping device

Clamping device

for ultrasound welding device with integrated heater (3 heater cartridges)

Pneumatic clamping device - I

Pneumatic clamping device - I

This pneumatic clamping device guarantees CNC reworking of diecasting parts. The parts are automatically centred thanks to the special design of the part placement area, and can only be placed in one position which enables operation of the device by untrained personnel.

Pneumatic clamping device - II

Pneumatic clamping device - II

This pneumatic clamping device enables simultaneous CNC reworking of up to four diecast parts. The part placement area is designed to match the parts and the swivelling clamp can be turned through 90°, which enables extremely accurate and simple reworking. Processing from three side is possible thanks to clamping of the device in the fourth axis.

Pneumatic clamping device - III

Pneumatic clamping device - III

The speciality of this pneumatic clamping device is its ability to rework the part both from the front and from the back. To avoid damaging, parts should only be subjected to minor pressure. In this case, the chuck has been designed as a wedge shape. This means that the parts will be in the correct position despite being subjected to high processing forces, and machining is possible from both sides.

Hydraulic clamping device - I

Hydraulic clamping device - I

This product is a hydraulic clamping system. As the entire part surface was to be machined, the part could not be fixed from above. For this reason the part is being clamped from the side by a hydraulic cylinder. The device has been designed so that the parts can only be placed in one direction so that operation by untrained personnel is also possible.

Hydraulic clamping device - II

Hydraulic clamping device - II

Hydraulic 90° swivelling clamps enable parts to be placed in the device without problem. Each part is held in position at three points, thus absolutely precise CNC reworking of diecast parts for the automobile industry from three sides is guaranteed.